液压胀形轧辊油槽深度的确定

对液压胀形轧辊（即国外的ＶＣ轧辊）辊套热装后的弹性变形进行了有限元分析，给出了确定油槽最小深度的计算公式。本文的有限元计算结果与实验结果吻合，某些结论可为液压胀形轧辊的结构设计提供理论依据。     

Longitudinal elastic waves in columns due to earthquake motion

An analysis is presented of longitudinal waves in a thin elastic column. Velocity is specified at one end, and the boundary condition at the other end is expressed in terms of a range of effective impedances of an attached structure. Propagation, reflection and interference of the waves are followed by the method of characteristics. Integration of differential equations along characteristics yields the wave-induced stress, which is then applied to problems of earthquake excitation. Numerical examples are given for recorded updown ground motion of the Kobe Earthquake.     

ANALYSIS ON ROOM TEMPERATURE TENSILE STRENGTH OF δ-Al_2O_3, FIBER / Al-12Si COMPOSITE

对δ－Ａｌ２Ｏ３纤维／Ａｌ－１２Ｓｉ复合材料室温拉伸强度的分析表明，在实验条件下该复合材料存在δ－Ａｌ２Ｏ３纤维的最小体积分数Ｖｍｉｎ和临界体积分数Ｖｃｒｉｔ，并求出其基体强度δｍ和室温强度σｃ－δ－Ａｌ２Ｏ３纤维体积分数Ｖｆ直线方程及纤维的临界长度ｌｃ和复合材料的剪切应力τＰ确定复合材料的ＲＯＭ预测曲线，应首先判断σｍ是否等于未增强合金的强度σｕｍ才能得出正确的结论。     

The variability and interdependence of spider drag line tensile properties

There is considerable interest in producing fibres that mimic the impressive tensile properties of spider drag line silk. It must, however, be recognised that these properties have been assessed largely on the basis of their average values; there can be significant variability about these averages. The natural variability can also serve as a useful indicator of the range of values over which particular properties of biomimetic silk may be tailored. Here we quantify several tensile properties of drag line from Argiope trifasciata spiders. We distinguish between two groups of properties on the basis of their statistical coefficient of variation. There is significantly greater scope for tailoring the viscoplastic hardening aspects of drag line, compared to the variability of the initial elastic response or the yield strength. We also consider whether elastic modulus, yield strength and viscoplastic hardening can be controlled independently of one another.     

碳纤维表面处理对铝电解用硼化钛阴极涂层性能的影响

硼化钛阴极涂层是铝电解用可润湿性阴极材料中的一种，具有优良的抗钠渗透性和对铝液润湿性，可以有效地延长铝电解槽寿命。碳纤维是硼化钛涂层材料的增强剂之一．对硼化钛阴极涂层的性能影响很大。本文研究了不同工艺的液相碳纤维表面氧化处理法对硼化钛阴极涂层抗拉强度和粘接强度的影响。采用PTIR检测碳纤维处理后表面含氧基团的变化，寻找影响硼化钛阴极涂层性能的原因，从而达到最有效地提高TiB2阴极涂层抗拉强度和粘接强度的目的。结果表明，采用工艺(1)(10％HNO3，80℃、恒温5min．超声波、5min)对碳纤维进行表面处理最合理，处理后碳纤维表面含氧基团的含量最高．用其制备硼化钛阴极涂层的抗拉强度、粘接强度最大。     

On an invariance principle for unilateral contact at a bimaterial elastic interface

This paper examines the axisymmetric elastostatic problem related to the unilateral receding contact at a pre-compressed smooth bimaterial elastic interface. The separation at the interface is caused by the action of axisymmetric stress fields of unequal magnitude, which are applied at any location of the separate halfspace regions. The analysis of the problem focuses on the determination of the zone of separation as a function of the pre-compression, the magnitudes and locations of the axisymmetric stress fields inducing the separation, and the elasticity characteristics of the halfspace regions. It is found that the radius of the separation zone can be evaluated in explicit form. In the particular instance when the loadings applied at the surface of the halfspace regions are equal in magnitude and distribution, the analysis reveals that the radius of the separation zone is independent of the elasticity properties of the halfspace regions and can be evaluated in exact closed form.     

Experimental evaluation of the strength distribution of E-glass fibres at high strain rates

A bimodal Weibull distribution function was applied to analyse the strength distribution of glass fibre bundles under tensile impact. The simulation was performed using a one-dimensional damage constitutive model. The results show that there were two concurrent flaw populations in the fracture process. The regression analysis using the bimodal Weibull distribution function was in good agreement with experiment.     

弹性筛管防砂技术

弹性筛管防砂技术是根据稠油油藏高轮次吞吐和蒸汽驱井防砂生产需要而研制的筛管防砂新技术。进行了筛管结构优化、加厚过滤单元外罩设计、固定方式研究、弹性过滤材料筛选、防腐实验研究等。室内试验表明，筛管的过流能力在900cm^2／m以上、渗透率在100μm^2以上、筛管抗内、外压强度达到20MPa、防砂粒径在0.1mm以上、耐温350℃、pH值在3～12之间不被腐蚀。现场试验证明，该技术防砂和抗堵塞性能好，防砂有效期长，地层适应性强，施工简便，防砂生产效果明显，具有良好的应用前景。     

桥用高性能混凝土的徐变与应用

基于2座桥梁混凝土徐变的试验结果，论述了高性能混凝土的长期变形特征，指出对提高混凝土弹性模量、减少徐变收缩的水泥、外加剂和骨料的三要素中，骨料的作用最明显．提出了徐变的湿度、尺寸修正方法与计算式，探讨了掺筋混凝土的徐变修正、徐变行为的温度效应及长期徐变等．     

Mycological and physical parameters for selecting suitable packaging material for pre- and post-irradiation storage of cereal grains in Ghana

Owing to the rough warehouse handling of storage sacks in tropical areas in Africa, a suitable storage sack should not support de novo growth of fungal spores because this would reduce the tensile strength of the packaging material and act as a springboard for infecting grain contents. This paper reports the effect of activity of saprophytic fungi on the tensile strength of jute and woven polypropylene sacks. New woven polypropylene sacks carried lower levels of fungal spores (1.3×10¹ cfu/72 cm²) than jute sacks (3.0×10³ cfu/72 cm²). The natural mould penetration and growth was examined on sections (4×5 cm) of both jute and woven polypropylene after previous incubation at relative humidities of 55, 60, 65, 70, 75, 80, 90 and 95% for 10 weeks by placing them on Sabouraud's Agar. There was a significant difference (P = 0.05 level of significance) between the higher penetration of mould growth on jute sacks and that obtained on woven polypropylene sacks. Saprophytic fungi (Aspergillus candidus, A. flavus, A. fumigatus, A. niger, A. japonicus, A. parasiticus, A. ustus, Fusarium oxysporium, F. moniliforme, Penicillium verucosum var. cyclopium, Rhizopus oryzae and Trichoderma viride) isolated from jute sacks reduced tensile strength, measured by an Instron Model 1026, by 50–75% after 10 weeks at 90% R.H. Same fungal species on woven polypropylene sacks did not alter the tensile strength. Woven polypropylene sacks did not absorb moisture whilst the moisture content of jute sacks increased by 5.3–6.0% in 10 weeks at 90% R.H. with concomitant increase in mould and yeast counts by 1–2 log cycles. Evidence is presented to show that there was a positive correlation between the final mycoflora on jute sacks and loss in tensile strength. No correlation, however, was found between the total aerobic bacteria on jute sacks and the concomitant reduction in tensile strength. Fungi therefore play a major role in the reduction of tensile strength of jute sacks. Sterilization by gamma irradiation (8.0 kGy) of jute and woven polypropylene sacks did not affect their intrinsic tensile strength. Woven polypropylene sacks therefore have many microbiological and physical advantages over the traditional jute sacks to merit their use for grain storage in tropical areas like Ghana.